Friday, 10 May 2013

E21 316: Making the 9Js fit the rear...

Summary of the bank-holiday weekends activities:

Pulled the N/S/R wheel-arch back out and cut it off.
Peeled back the inner-skin of the arch and cut about 4 inches off it.
Cut a notch out of either side of where the arch meets the bumper shut-line.

The outer rim of the arch is now way off the tyre, but I could see a black rubber mark further up inside the inner wheel-arch.




The car was now rolling with a driver in, but one test drive revealed that any bump causes rubbing and the rim of the tyre caught the sharp edge of the cut inner arch, which chewed it pretty bad.



I've made a lot of space up there, so before I start hacking away any more arch, I'm going to buy smaller, lower profile tyres, I think that is now clear.

No comments:

Post a comment