Monday 20 May 2013

E21 316: Stretched Toyos first try + more spending.

Tried out the 8Js on the front with the new 195 Toyo T1Rs using 20mm spacers and there's a lot more room at the arch-lip now. The tyre doesn't catch at all turned hard-left, thought it would going over a bump. Hard-right the tyre is still catching the front valance slightly, but about 1cm cut away should be enough now and a little off the fender where it protrudes from the bumper - none of the bumper itself though. I had hoped to get away with smaller spacers on the front, but even with the 20mm spacers from the rear, the inside rim of the wheel is still 5mm inboard of the 15x7Js and there is not a lot of headroom.


I just haven't found time to try out the 9Js on the rear today as the valve is bust in one and on the other, about 6 inches of the bead has just been refusing to seat. My leg just couldn't take any more foot-pumping so I got hold of an air-compressor from a friend and took the tyre to nearly 90psi this morning, but it still wasn't having any of it. Eventually, after two goes deflating the tyre almost completely and trying to brush in soap between the tyre and rim, then taking it back up to about 65psi, the bead finally popped. The maximum pressure rating on the tyre is 50psi, though it says use no more than 40 to seat the bead, so it just goes to show that when the seal is tight enough it can take over twice that and still not seat. Bead-blaster machines can jet up to 200psi in one go and that doesn't even shred the tyre to bits so I'd be keen to know at what pressure a good new tyre would rupture at. Even so, always take the utmost care when inflating tyres past their rated pressures at home!

Apart from 4 new valve-cores (£2.99) and a valve removal-tool (£4.99) from Halfords, I've had to do yet more spending on parts as the project can't move on without them and I want to be getting somewhere near finished next weekend when we have the bank-holiday off. First up are adjustable camber-plates for the front, a must for style and it will likely give me a bit more room to play with before starting to cut. They're not approved for sale in the UK, so lets hope they make it here from Poland before the weekend - fingers crossed eh! Looking forward to these, though quite pricey @ £105 delivered, but whatever, they're the only ones of their kind. It's also time to stop digging my heels in and buy another set of spacers to go on the front, swapping the ones over from the rear is becoming a chore. I'd hoped to get some alloy ones to save hub weight, but again for easy access, the right centre-bore without more spigot-rings and to get the bolt-on kind I want, yep you guessed it, more steel ones. Another £59, oh well, roll on next weekend.

No comments:

Post a Comment