E30/E28: Faulty AFM (Air Flow Meter) repairs, worn carbon-track quick fix

** FOR ADJUSTING AFM AIR/FUEL RATIO SEE THIS POST **

The AFM or Air Flow Meter uses a metal flap that is opened air entering the engine to move a brass arm up and down a carbon-track. The position of the arm along the carbon track alters the electrical resistance through the circuit and this lets the ECU know how much air is coming in, so it can deliver the right amount of fuel to the injectors. The E30 uses a BOSCH AFM unit, also used in many other BMWs with Motronic or Jetronic injection systems.

The analog electrics in the BOSCH AFMs rarely ever fail, but there are two areas that are failure prone after higher mileage - a worn carbon track and a faulty air-temperature sensor.

E30/E28: Adjusting AFM (Air-Flow Meter) - change air/fuel rich/lean mixture

 ** ADJUST YOUR AFM SETTINGS AT YOUR OWN RISK **

This is for BOSCH AFM units, fitted to most E30 and other BMWs fitted with Bosch Motronic or Jetronic injection systems.

The AFM, or Air Flow Meter, is a metal flap that is drawn open by air entering the engine and the position of the flap tells the ECU how much air is coming in so it can inject the right amount of fuel. The stock parameters for the AFM are set at the factory and unique to each car and BMW recommend that these settings should NEVER be adjusted... so do it at your own risk!!

Why would the AFM need adjusting??

• You have done a ‘gas-test’ and the results show your car is running rich (too much fuel for amount of air) or lean (too much air for the fuel being supplied) and wish to adjust for emissions / fine-tuning purposes.
• You have an air leak after the AFM, so more air is getting in than the ECU is supplying fuel for and the engine won’t run, especially when cold.
• You have an over-fuelling problem where too much fuel is being supplied for the amount of air and flooding the engine.

Adjusting the AFM in the second two instances is a quick and dirty way to get your car running well enough to drive it, but is not a long-term fix for an underlying problem, so bear this in mind before messing with the AFM.

E30 318i: Replaced AFM (Air-Flow Meter)

I’d been messing with my AFM in order to get the car running ok when cold and when I finally fixed the massive air leak on the inlet manifold I then struggled to reset the AFM back to standard. 

In order to get the M40 to idle ok while the engine was cold I adjusted the mixture setting to run richer. Obviously this was providing enough fuel to stop the engine cutting out while the plenum was filling with as much air as the cylinders could gulp through the gap in the manifold gasket. It runs and drives ok in this setting, but idles quite high (about 1100rpm) and you can smell the stink of neat petrol out of the exhaust. Ok for short trips shunting the project car around but will need addressing to enjoy it before summer ends!

The real problem began when I had repaired the gasket, got the engine running smoothly and then tried to reset the AFM back to a stock, or near stock value. To begin with I had been putting marks and taking photos to recall where the settings were before I started messing, but you know how it is, once you get immersed into a several day long tweaking session (take that as you will!) the tendency is to get lost along the way.

I gave up trying in the end and decided the only way to dial this engine in and be sure I was not fighting with a dodgy AFM was to buy one that had not been messed with. This is in my interests anyway, as I got one from a car with far lower miles on it so the carbon-track is less worn and I know the air-temp sensor is OK too, which was a doubt with the original one.